Choose a category on the left to view all FAQ's by section.

You may also search articles to find answers!

 

 

Find out more about our Support Program  

Main Page > Flash Memory Programming (01-08)

Articles in Flash Memory Programming (01-08)

01 - Image not being programmed or loaded at the correct memory address. Image not being programmed or loaded at the correct memory address.   Before going any further please check if the flash/memory location is working properly. Perform a few writes and reads from the memory location, use MMH for 16bit, MMB for 8 bit, and MMD for 64 bit flash. MM 0xff000000 0x12345678MD 0xff000000

02 - Can the BDI program NAND flash? No, the BDI does not support programming NAND flash.

03 - Flash Programming Failed After programming the first 512 bytes into flash the BDI2000 gives an error and stops programming. Same thing happens when we run a verify. When we read back the flash it appears to be programmed correctly.

04 - I keep getting the message "Flash Programming Failed" in the BDI Probe. How do I setup my Flash Programming? There are several reasons that flash programming could be failing. The most common one is that the config file is not setup correctly for flash programming.

05 - How can I use the Physical Address of my flash memory to program it? How can I use the Physical Address of my flash memory to program it?

06 - Can I program my flash with bdiPro when I have the flash bus bits reversed? Can I program my flash with bdiPro when I have the flash bus bits reversed?

07 - My Flash configuration has the bits reversed; can I still program flash using the BDI Probe and the bdiGDB firmware? Flash memory is usually connected so that the MSB of the processor is connected to the MSB of the FLASH.

08 - Does Abatron publish a list of NOR Flash devices they support with the BDI probes? Yes, you can download the pdf file here - Flash Support